Welcome to the ProTrak User Community Support Forum . The forum is designed around the chapters in The Manual. Please post your questions in the appropriate subforums. You may "Subscribe" to topics and reply by email.
4:28 pm
April 28, 2015
Jim,
In setting up for a session I use the "re-block trains in staging" to reduce wear and tear on the yardmasters. I noted that these lists do not indicate which order the cars are in, i.e. loco to cab. How can I tell?
Also, I have several coal trains and coal empty trains that run during a session from staging to staging. Now, I have them set as connecting trains and have to unload and load the coal loads in the hoppers before each session.
As of now, I have these trains set that the power runs around the train; however, if I set the option that the train starts from this staging, or train continues as same train, will either of these options eliminate my need to swap loads from cars?
Many thanks.
Jim Brewer
Jim,
>there should be an option to reset to origin.
Howard is talking about a waybill datafield. The "CIT" datafield.
If the CIT waybill-number entered in the CIT datafield is the same as the waybill-number being edited, there are options for "empty-load" and "reset to origin".
If you select the "reset option" the intent with ProTrak is that you are moving the cars with a reset waybill back to their origin between sessions (or even during a session).
OK?
Jim
Most Users Ever Online: 189
Currently Online:
11 Guest(s)
Currently Browsing this Page:
1 Guest(s)
Top Posters:
Nashville: 248
Joe-SVL: 243
casowest: 95
Jim Brewer: 92
Mark Stafflrd: 58
Bob: 53
Fred: 43
John V: 43
jjoyce1: 32
Peter Jackson: 27
Member Stats:
Guest Posters: 0
Members: 259
Moderators: 0
Admins: 5
Forum Stats:
Groups: 3
Forums: 13
Topics: 432
Posts: 1815
Newest Members:
Fred52, ferretjack, Frank, bcole_-8@rogers.com, frich1230, waffle2@mac.com, innovativerc@gmail.com, KRFARRINGTON, George Giles, NandWSRY55Administrators: earlyrail: 71, friscomike: 130, webmaster: 1, hunter48820: 23, Jim Moir: 489