Hi Jim and All,

I've been having a problem with the proper routing for some cars in some trains at the beginning of a session before any trains have been run.

In Operations, when I go to "Yardmaster, List/Print cars in yard," and then open the list for a particular yard, I then select the "Yard Check" and then "Cars in Yard" buttons at the bottom of the window.  This will open a window with all the cars listed that are presently in that yard.

Next, I select the "Destination Train" Column.  I can now go down this list to see if the cars are in the correct train by their destination.

I have found incorrectly routed cars in enough trains going to staging and some local and transfer trains, that I have to do the following before I start each session. 

In Operations and the "Current Trains in Lineup" window, I do the following for all trains not originating in staging.  

Click on the train to open the "Reporting Movement" window. 

Then click the "Report" button.  This will open another window which allows you to open the train in the yard and an additional window will also open which will allow you to setoff and trim your train. 

If you select the "Setoff and Trim" button, the misrouted cars will be removed from the train and placed in their correct train.

You can verify that the consist has been corrected by making another check of the "Yard Check" window referenced above.

My question for Jim is if there is a way to have just one master button which when selected would open and trim all trains.  With 60+ trains in my lineup, it takes a fair amount of time making all these checks and there is always the possibility of missing one or more of them. 

This becomes a greater problem when we run continuous sessions in the "Session" mode as I have started doing.  I want to keep the time between the end of a session and beginning of the next to a minimum since I will have people standing around as they wait for the trains to start running again. 

Thanks, Andy